Foamie RC Glider Tail Feathers

Glassed Tail Feathers for Foamie RC Glider:

Home

Be aware that these modification add significant weight to the tail of your RC glider and will require substantial nose weight to offset. This is particularly applicable to kits with short noses like the foamie P-51 and TA152 and will result in a slightly higher wing loading.. Also, these modification are generally not allowed for foamie RC Glider racing. Check your local club rules if you plan on racing.

3oz Glass cut for each side of pre-sanded balsa tail feather

Glass one side at a time. Tape on back side to ensure epoxy does not migrate onto unwanted surfaces.

(click on pictures for larger images)

Glass texture should show as long as there is not too much epoxy. It's better to go light and then add a little more if there are any dry spots on the glass.

Parts ready to apply thin coat of epoxy. Apply epoxy then lay glass on top.

All done with this one!

Trim off excess glass with an exacto knife or razor blade

Reinforced tail section to inprove strength.

Elevator Linkage for standard hookup.

Image of bottom side once assembled.